浙十一选五开奖一定牛





PA211 Power Transformer Dyna PAS for Dynaco Replacement MADE IN USA

PA211 Upgrade and Replacement transformer for Dynaco PAS2, PAS3 and PAS3X preamplifiers.
Direct bolt in replacement-no drilling or cutting required to install. New unit, MADE IN USA by transformer professionals with decades of experience manufacturing high voltage transformers.
Guaranteed to meet or exceed published specifications for the original Dynaco unit. Of course you can use these for do-it-yourself preamp projects, it will power up to 4 12AX7/ECC83 or similar tubes. You could build a nice buffer preamp or mic pre. For guitar you could build a fender front end clone. Check out our reverb transformer and a twin reverb schematic for your tube reverb project.

For the connection diagram for the PA211,


Runs cooler, regulates better than original due to improved insulation technology that allows larger gauge secondary wire, resulting in more than 50% less copper resistance on the secondary than the original. Secondary is 330-0-330VAC at 15 ma DC rectified current, plus 12V at 800ma for filaments & pilot lamp. Primary is 120VAC 50/60 Hz.

Transformer is 2 1/4 inch high by 2 inch wide by 2 1/4 inch deep over the end bells. Weight 1 lb 4 oz.



pa211$89.95

Triode, USA
Customer Service
M-F 9AM-4PM CT 1-800-774-3201
Email us Anytime: questions@junqf.icu
唯彩看球杀号 大乐透最近30期走势图综合板 江苏体彩e球彩玩法介绍 3d和值和值尾振幅彩经网 大乐透100期的走势